Saturday, April 6, 2013

Porsche 911 GT3 R: Last for Porsche 997



- 2013 will be the last time Porsche 911 race car is built on the next generation platform 997.Although the Porsche 911 GT3 Cup race car and 911 RSR has switched to using the 991 chassis platform generation, but the 911 GT3 R is still using the chassis of the 997 platform, this will be the last one 911 GT3 platform built on the chassis of the 997 race participants.
According to information posted on MotorAuthority, yesterday, revealed that the Porsche 911 GT3 R will be raced its 2013 Porsche also simultaneously affirmed the car still get upgrades like last season here, which focuses on improving the aerodynamics.
The car has front fender and wide, there are more small plates side pressure down the road when driving at high speed, the wide diffuser system, and especially the large rear spoiler. All has been fine-tuning in the wind tunnel Porsche.
Wheel arches front and rear of the race car was extended 50 mm, the rear wing extended in width of the car right, and change the angle to optimize aerodynamics.
The expansion also helped Porsche bodywork layout of the larger cake in the front axle and rear axle.
Aerodynamic design of the new 911 GT3 R enhances the ability to put pressure on the ground, allowing the vehicle can operate at high speed, more stability when cornering or braking.
Transmission system of the vehicle is kept, the car still has a 500 horsepower, 4.0-liter engine - six-cylinder flat. Combined with this engine is sequential six-speed gearbox with paddles under the steering wheel. The power from the engine is transmitted to the rear wheel of the race car.


Porsche also added that the team has possession of the 911 GT3 R from 2010 can contact the car to upgrade to the latest version. There is no information about the price of the new 911 GT3 R.














No comments:

Post a Comment